24VDC SPDT 5-Pin PCB Power Relay 16A Replacement for OE G2R-1-E-DC24, Through-Hole Solder Pins, Control Relay for Vehicle/Equipment Circuits

24VDC SPDT Power Relay Replacement (OE: G2R-1-E-DC24)This listing is for a compatible replacement relay identified by OE number. Please confirm fitment by OE number and your vehicle/equipment service manual before purchase.Key SpecsCoil voltage: 24VDCContact form: SPDT (1 Form C), 5-pinCurrent rating: up to 16A (resistive) — rating depends on your circuit and switching conditionsTerminal style: through-hole solder pinsType: non-latching electromechanical relayWhat it doesUsed to switch power to loads in control circuits (e.g., motors, heaters, solenoids, lighting, or accessory circuits) when the correct voltage and wiring are used.Common symptoms of a failing relayIntermittent power to the load, clicking without switching, or no click at allLoad stays ON/OFF when it should change stateHeat/discoloration at terminals or loose seating in the socketInstallation notesDisconnect power before replacing.Verify 24VDC coil requirement and confirm the 5-pin SPDT pinout (coil + COM/NO/NC) matches your footprint/socket.After installation, ensure secure seating and check for abnormal heat under load.Fitment reminder: Because installation locations and applications vary by design, confirm fitment by OE number (G2R-1-E-DC24) and the vehicle/equipment manual or wiring diagram.

• Specs: 24VDC coil; coil resistance approx. 1.1 kΩ; SPDT (1 Form C) contact; up to 16A (resistive); 5-pin through-hole solder terminals; non-latching. PCB power relay with safety-oriented insulation (dielectric strength 5kV; surge resistance 10kV between coil & contacts). Operating temp: -40°C to 70°C (no icing/condensation). OE reference: G2R-1-E-DC24 (also shown as G2R-1-E DC24).
• Install/replace: Disconnect power. For PCB use: note the pin layout, desolder the old relay, clean pads, then solder the new relay without overheating pins. For socket/module use: pull straight up, inspect terminals, and seat fully. Confirm your system uses a 24VDC coil (not for 12V-only circuits). Match the 5-pin SPDT layout (coil + COM/NO/NC) to your footprint/socket and wiring diagram. This is a through-hole PCB power relay; some systems use matching plug-in sockets—confirm fitment by OE number and the service manual/wiring diagram.